7x Xiranite "HeptaForge" [SubAIC, minPower]

NOTICE: EnKAD link integration on this site is not up to date at time of writing. Use this link: https://enkad.enka.network/?id=H9p4M2e6Y2b4V4 The design and blueprints have been updated as of April 22, 2026. Peer feedback has been incorporated to make placement easier, and I have fixed a bottleneck issue of the conduit that prevented the center top and top-right forges to lose productivity. OUTPUTS: 210 Xiranite/min (7 belts) 30 Sandleaf Powder/min (1 belt) INPUTS: 7 Clean Water/sec (420/min) (7 Fluid Pumps) INSTRUCTIONS: The full setup is divided across three blueprints: QuadForge (A): EFO01A5ieA3e8AEe49AeO QuadForge (B): EFO0136uI3eIi3a9e0579 HeptaForgeAddon: EFO01O3E2O126OI8E94e4 In the diagram, these prints are respectively the bottom left, bottom right, and top. The conduit needs to be supplied by two pumps. Other inlets require one pump each. OVERVIEW: Like with the original QuadForge design, this design minimizes power use through full machine utilization and abstention from use of Protocol Stashes. This design is sized to fit exactly into a fully expanded Wuling outpost, e.g., Sky King Flats. NOTES: This design requires 7 water pumps, of which you can place 5 with relative ease on the nearby water's edge. A convenient tip for the last two pumps is that you can place them farther back on the other side of the water "behind" the five existing pumps. It's possible to place a conduit there as well, as shown in one of the attached pictures. An eighth pump is not needed, but there is one more that can be placed to the right of the pictured area in demo image.